I once needed to bend four lengths of copper tubing identically, with three bends each, none of which were coplanar. That was hard with the conventional “jig” approach. I ended up with imperfect results, and that only after several false starts and much frustration. This little gem would have spit them out lickety-split. Must have tube bender – even though I can't think of a single use I could make of it...
Saturday, June 21, 2014
Now that I've seen it...
I once needed to bend four lengths of copper tubing identically, with three bends each, none of which were coplanar. That was hard with the conventional “jig” approach. I ended up with imperfect results, and that only after several false starts and much frustration. This little gem would have spit them out lickety-split. Must have tube bender – even though I can't think of a single use I could make of it...
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment